Monday–Saturday 08:30–18:30 · 24/7 technical support

Compressor and Gas Cooling at LNG Facilities: BOG Compressors and Auxiliary Circuits

Compressor and Gas Cooling at LNG Facilities: BOG Compressors and Auxiliary Circuits

Compressor cooling at an LNG facility is needed for the safe and efficient operation of the compressors that collect and compress boil-off gas (BOG) from the tanks. LNG itself is kept at cryogenic temperature, but the compressors handling the boil-off gas, their oil circuits and the gas leaving the compressor heat up, and this heat must be removed.

Which points are cooled?

  • Compressor cylinder jackets and motor
  • Lubricating oil coolers
  • Interstage and discharge gas coolers

These loads are usually handled by a chiller or dry cooler through a cooling water or glycol circuit.

System selection

Capacity is calculated from the compressor manufacturer's heat rejection data, the required cooling water temperature and the local climate. For continuously operating plants a redundant (N+1) design and controls suitable for uninterrupted operation are recommended.

Hazardous areas (ATEX) and layout

In gas facilities, explosive atmosphere zones are defined by the site risk assessment. The location of the cooling unit, its electrical equipment and piping must follow this classification. In most projects the chiller is placed outside the hazardous zone and reaches the compressors and heat exchangers through a cooling water or glycol line. The final layout is set by the site ATEX documentation and the approval of the responsible engineer.

Operation

Cooling water temperature and flow should be monitored, heat exchanger fouling checked and the glycol ratio verified seasonally. Remote monitoring helps detect faults early.

The purpose of cooling at an LNG facility

LNG is stored as a liquid at very low temperatures; that temperature is achieved by cryogenic processes, not by a chiller. The chiller removes heat from the auxiliary equipment: intercoolers and oil circuits of the compressors that compress boil-off gas (BOG) from the tanks, pump motors, electrical and control panels and, in some processes, heat exchangers.

Uninterrupted operation

At LNG facilities, a cooling stop can stop the compressors, which can leave boil-off gas unmanaged. A redundant (N+1) design with two or more chillers and pumps is therefore usual, and fault and temperature alarms are connected to the control system.

Information needed for the project

  • Equipment to be cooled and the heat loads given by the manufacturers
  • Required water temperatures and flows
  • The facility's hazardous area classification
  • Highest and lowest ambient temperature of the site

To see all cooling applications in the energy and gas sector in one place, visit our energy and gas sector cooling page.

Frequently asked questions

Do you cool the LNG with a chiller?

No. LNG is kept by cryogenic systems; we supply the circuits that cool the compressors, oil circuits and compressed gas.

Is redundancy necessary?

It is recommended where downtime is not acceptable.

Why is a BOG compressor cooled?

Boil-off gas heats up as it is compressed; without intercooling, compressor efficiency falls and the temperature safety trips.

Where is the chiller installed at an LNG facility?

The cooling unit is installed outside the hazardous area boundary and connected to the equipment by a water circuit.

Send us your compressor data and target temperatures; our engineers will calculate the cooling requirement with you.

Work with us

Let's choose the right system for your process together

Send us your machine data or a photo of your plant; our engineers will calculate the heat load and prepare your written quotation within 24 hours.